Water Based Spray Rigid PU Foam

• Customization: Available
• Material: Polyurethanes/PU
• Usage: Engineering Plastics
• Model NO.: SDP1234
• Plastic Properties After Heated: Thermosetting Plastic
• Plastic Forming Method: Spray
• Color: Yellow
• Transport Package: Iron Drum
• Specification: 220kg
• Trademark: shunda
• Origin: China
• HS Code: 39072090
• Production Capacity: 50000ton/Year
• Package Size: 60.00cm * 60.00cm * 90.00cm
• Package Gross Weight: 19.000kg

Product Description

Product Description

SDP1234 is a kind of light, insulation, noise reduction material which used for the alternative solution for the traffic industry. The open cell flexible PU foam can be used to form a seamless airtight sealing layer inside the bus compartment, so that will effectively reduce the heat loss, noise and vibration, and greatly improve the comfort of passengers. SDP1234 type blend polyol foam has the characteristics as following:
 Light.
The strong adhesive force, convenient construction and no seams.
Open cell, excellent noise reduction performance.
Good insulation and fireproof performance.

Product Parameters

Physical Properities                                                                                                      Test Method Standard                                             Metric                     Value
Core Density	GB/T 6343-2009	kg/m^3	<10
Initial Thermal Conductivity	GB/T 10294-2008	W/(m·K)	<0.042
Flammability	GB 8410-2006	A-0	A-0
Odor test(80ºC)	Q/ZK JS10-000-201302	/	3.5
Ormaldehyde Emission	VDA275:1994	mg/kg	<10
Fogging Test	DIN75201:2011B	mg	≤5
VOC(Benzene, Methylbenzene, Imethyl, Benzene, Phenylethane, Styrene)	VDA277:1995	μg/g	<10
TVOC	VDA277:1995	μgC/g	<50

Importance: The above mentioned are typical test values, and the specific data may vary slightly due to environmental conditions. For our products, the data are not legally binding.

Usage Attentions

The thickness of one gun spray foam should not exceed 50 mm. If over 50mm, which may cause foam charring or spontaneous combustion and poor foam performance.
It is suggested that spray next layer of the foam after the internal temperature of last spray foam blow 25ºC. And the maximum thickness spray during 24h period is 203mm(8inches).
Like most of foam product, foam made by SDP1234 is combustible. An thermal barrier must be installed in accordance with approved construction standards.
The service temperature of the foam with SDP1234 is between -60~80ºC.

Storage Recommendations

The blend polyol should be stored in the sealed container to avoid the absorption of water vapor. During the transportation, it should avoid serious shake and strong sunlight. It should be stored in ventilated place, avoiding light, water and fire. Recommended storage temperature is 15~25ºC.

Safety Precautions

Direct contact with SDP1234 type blend polyol can lead to moderate eye irritation and mild skin irritation, which can cause skin allergies. Repeated inhalation of high concentration of volatile gas will cause respiratory allergy, and should be treated immediately. Anti- inflammatory and anti-allergic treatment measures should be taken.
Please be careful in the operation to prevent contact with the skin and splash into the eye, please wear the necessary protective equipment (gloves, protective goggles, working clothes, etc.).
Once splashed on the skin or the eye, rinse with water immediately for at least 15 minutes, and the skin is washed with soapy water. Please seek medical treatment immediately after swallowed.